How to Use a Soda Siphon

All our soda siphons work the same and use our standard 8 gram co2 cartridges.

Follow these basic instruction to carbonate water using any of our soda siphons.

1 - remove the soda siphon head and siphon tube.

2 - fill the soda siphon about 2/3 full with cold water

3 - replace the head and tube. Make sure it's secure so co2 gas does not leak out.

4 - insert 1 co2 cartridge into charger holder and screw onto head piercing pin until you hear a hissing sounds. This indicates the gas has been successfully released into the water.

5 - allow the soda siphon to sit for approximately 15 minutes

6 - shake the soda siphon vigorously and let it sit for another 5 minutes

Now you should have nicely carbonated water for making your specialty beverages. It's very important to be patient and follow the last two steps. Many people try to immediately dispense the carbonated water after putting in the co2. Unfortunately, the water will come out due to pressure, but it will not be carbonated. It's important to wait for the gas to permeate the water.